Racelogic USER GUIDE Guida Utente Scaricare il pdf (Pagina 12)

VBOX MICRO MANUAL

Page | 12 06 August 2014

Connecting an Input Module to the VBOX Micro

The VBOX Micro can connect to any one of the following Racelogic input modules and then include the data

from each channel in the logged VBO file. The VBOX Micro will automatically log all channels from a

connected Input Module providing that the module is connected before the power is switched on.

Part Numbers

Descriptions

Connection Cable

RLVBTC8

8 Channel Thermocouple Interface

RLCAB063

RLVBADC02

8 Channel (10bit) Analogue Interface

RLVBADC03

8 Channel (16bit) Analogue Interface

RLVBFIM03

4 Channel Frequency and Pulse Counter Input Module

RLVBMIM01

Mini Input Module

RLVBYAW03

Yaw Rate Sensor + 2-Axis G Sensor

RLCAB065

RLVBIMU04

Inertial Measurement Unit

Configuring the Input Modules

To configure an input module you must connect the module directly to the computer via a serial cable, the

channels cannot be setup via the USB port on the VBOX Micro. The software required will be Stand Alone

Module Setup software or Racelogic Config depending on the module being configured. The module can

take power from the VBOX Micro both during operation and during configuration.

Connecting a Display to the VBOX Micro

A Multi-Function Display (MFD, part number RLVBDSP03) can be connected to the CAN output of the VBOX

Micro using an RLCAB063 cable. This then provides the user with a live display of the VBOX Micro data

parameters, plus the ability to show live results of acceleration and deceleration runs and also display Lap

times.

For details of full functionality please refer to the Multi-Function Display user manual.

Whilst connected to the VBOX Micro, the MFD will have full functionality except for the ability to display

trigger-activated brake test results.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Nessun commento

Racelogic USER GUIDE Guida Utente Pagina 12